A tall starting point for a custom gate

Instead of welding a gate frame from raw stock, begin with precut members, pre-drilled hardware locations and bracing inside the corners. This 6' x 8' frame kit fits builders, designers and homeowners after a taller gate for side yards, walkways, gardens, pool areas or HOA and multifamily properties, then fill it with the profile that fits the project.

Kit contents

• Uprights, two
• Horizontal top and bottom sections
• Side post and T stopper for the receiving side
• Hinge hardware for the swing side
• Internal corner bracing

Infill and latch hardware are chosen separately.

Material and finish

The frame is 6063-T6 structural aluminum finished in powder coat that meets AAMA 2604. Because aluminum cannot rot, swell or form iron oxide rust, which makes it practical in coastal, humid or hot climates. Routine care is cleaning, checking hardware and keeping the gate aligned.

Choosing infill

The frame takes 3/4 in. or 1 in. profiles, so it can pair with Profile 40, Profile 60 or T&G slats and coordinate with cladding or posts elsewhere on the property. Confirm the infill's weight and fastening method suit the frame before assembly.

FAQ

Can I use it for a pool gate?

Possibly. Whether it meets pool barrier rules depends on the finished gate and your local code.

Are slats included?

No. This is a frame-only kit.

Is an 8 ft tall gate allowed where I live?

Check local regulations and site conditions before building.