Infill sized for a 4 by 6 ft gate

This is the infill box used in the complete Profile 40 4x6 walk gate kit. Every board is factory cut to 39 in., so they drop into a 4 ft wide frame at one consistent length. Use it to give a new gate the same look as your Profile 40 fence line, or to replace worn infill on a frame of that size.

What is in the carton

• Sixteen Profile 40 boards
• Each cut to 39 in.
• Wall: 0.047 in.
• Alloy: 6063-T6
• AAMA 2604 powder coat in Black, Bronze or White
• Gap: no less than 3/8 in.

Frames, hinges and posts are not part of this box.

How the Profile 40 look reads

Profile 40 is a 4 in. board. The wide face shows fewer lines than skinny slats, and a gap of at least 3/8 in. stops the gate from feeling closed in. You will often see it beside patios, side yards and front walks, and the aluminum will not rot or warp.

Picking the right box

Go by frame width. A 6 ft wide gate uses the 62 in. Profile 40 box instead. If you want zero gaps, the 39 in. Profile 60 T&G box interlocks. Check your opening and frame before ordering, and ask Globus Gates if your frame is not one we list.

Completing the gate

Our complete 3/8 in. gap kit bundles this carton with the DIY-only 4 by 6 ft frame kit plus a 7/8 plug. Building it yourself from parts? Begin with that frame kit, then choose posts suited to either wall mounting or a concrete footing.

Are hinges included?

No, this box holds boards only.

Can I get it in White?

Yes. This 39 in. box comes in White as well as Black and Bronze.