Profile 60Profile 60 T&G Boxed 2-Way Post Fence Kit 8 ft W x 6 ft H, No Gap
Highlights
- Profile 40 slat, 18 ft long
- Yellow Oak wood grain finish
- 6063-T6 aluminum
- Suits sliding gates, pergolas and wall toppers
- Non-combustible aluminum, Zone Zero ready
Long Yellow Oak stock for wide spans
Short slats leave visible joints when an opening is wider than the board. With 18 feet to work with, this Profile 40 slat can cross a large sliding gate, top a long masonry wall or fill a pergola bay in one continuous piece of light, warm wood grain.
At a glance
- Finish: Yellow Oak wood grain
- Length: 18 ft
- Profile: Profile 40
- Material: 6063-T6 aluminum
Where it works best
- Sliding gates: carry the grain unbroken across a wide frame.
- Wall toppers: add long timber style lines above block or brick.
- Pergolas: trim pieces to each bay for overhead shade.
- Odd fence sections: cut unusual widths from one length so the tone matches.
Working from one long piece also cuts down on end finishing and joint alignment.
Cutting and handling tips
Draw up a cut list before you start so that no length is wasted. Keep the slat fully supported while you cut, and protect the grain surface during handling. Delivery or pickup of long material depends on your location, so arrange it with Globus Gates.
FAQ
Can I combine it with 6 ft slats?
Yes. Both lengths use the same profile and the same Yellow Oak color. Place a single order for the whole job to keep the shade consistent.
Does it need sealing like real oak?
No. The grain is on aluminum, so it will not rot or split and only needs a rinse now and then.
When is the 6 ft size better?
For standard sections and single gates, the shorter slat is easier to handle.
Reviews
Bought this? Write the first review
Complete the project
Profile 60Profile 60 T&G Boxed 2-Way Post Fence Kit 8 ft W x 6 ft H, No Gap
Channel Cover Spacers 1/2 in. – Black
2.75 in. 2-Way Post 11 ft – Black
3/8 x 3-3/4 in. Wedge Anchor
Reviews
There are no reviews yet.